The standard removal technique is to tap the bung with a hammer to loosen it and try to remove it with a single hex spanner or socket, if this does not work try to use a screwdriver in the centre at the same time as using the spanner.
It is common for the bung to become stuck if it is done up too tight, if this is the case chisel the bung from the side. The bung will break in half and the tension will be released from the thread and the remainder will unscrew with your hand. If you do this you will obviously need to buy a new bung, I suggest you buy a brass one from a radiator shop.
Katie
Can you fit a 300tdi front bumper to a 200tdi
no
how do you screw off front bumper to a land rover discovery 2001
The front fenders on your Land Rover Discovery are held in place with eight retaining bolts. Remove the retaining bolts and the front fender will come off.
lsndrover discovery 2007 front fogs not working and switch not showing on on dash
On a Series 1 Discovery just UNBOLT the CENTER section of the bumper fascia. (the plastic part) Then, using a dremel or similar rotary tool, cut the ends @ the angle line to match.
10 to 12 MPG
at the front of the engine beneather the camshaft pulling
Discovery Series 1 and Series 2 share engines but not all brackets with the Defender, this is the 200TDi, 300TDi, TD5 and V8 (where available).
Land Rover Discovery was created in 1989.
Premium Unleaded
Land Rover Discovery Series 1