• 
• 1 answer

Truck utility medium, other variant is truck utility light

• 
• 1 answer

i think this is the Calatrava designed bridge in Barcelona...

Possibly, but there are Santiago Calatrava bridges all over Spain including some tiny out of the way towns like Ondarroa up in Guipuzcoa. What i'd like to know is where is the crystal like building where the couple gets out of the Rover for some formal affair.

++ The arch bridges in Ondarroa, Bilbao and Valencia are SINGLE arches (there are harp bridges in Sevilla and Valencia). This one does look very much like the Bac de Roda bridge in Barcelona.

• 
• 1 answer

the fuel pump might be week get a fuel pressure tester and check it out

• 
• 1 answer

above the front tailshaft, on the left side of the engine when looking at the engine

• 
• 1 answer

You need to pull both coolant hoses going to firewall. That will give you an approxiamate location. It will be sandwhiched in between ducting on int. Under dash in that area. You need to split the duct R&R and attach hoses. Replacement easy. Getting to it oft times a pain. Core itself usually around 30.00. You might consider paying to have it done or bypassing. (Just connect the hoses together)

• 
• 1 answer

fuse box under bonnet

• 
• 1 answer

1n 1948 It used to be owned by rover then it went to BMW then ford but recently TATA, an Indian Company boght both Land Rover for 1.8 bilion and Jaguar that's why the range rover supercharged is th ejaguar engine

So now Land Rover and Jaguar are Owned By TATA

• 
• 1 answer

Idealy you should always replace the head bolt. most cases it is mandatory. check your specs. if the tightening sequence finishes with a 1/4 turn or some non foot pound reference then the head bolt must be replaced.

• 
• 1 answer

Range Rover Classic EFI will foul spark plugs if you start and stop the engine when cold.

All models with 3.5, 3.9, 4.2, 4.0, 4.6 will wear out camshafts and/or blow headgaskets from 150,000km to 200,000km.

• 
• 1 answer

There are a number of reasons for this, but varies between petrol and diesel. Diesels dont like the cold. The diesel engines in the 75 are BMW common rail engines.

• 
• 1 answer

The air intake temperature sender is located at the right hand side, back of the engine when looking from the front of the car. It is found screwed into the inlet manifold at the top of the engine. Disconnect wiring and unscrew sensor.

• 
• 1 answer

if i remember correctly the bolt you are looking for is on the back of the pump losen all bolts and all should be fine

• 
• 1 answer

It is located in a radiator hose, on a Petrol this is on the left side of the fan when looking at the engine.

• 
• 1 answer

DONT FORGET Turn OFF the Engin KEY, and dont let any Elctrical system work, at all, IF siren sounds when the battery is rconnected it can NOT be turned off in the normal way ie by operating the handset buttones To deactivate the alarm turn the starter switch to position '1'.

• 
• 1 answer

firstly remove the rear wheel and brake drum

remove grease cover from hub centre

undo the nut ( v tight ) from hub

hub should then come off

place hub in a vice or hydraulic press

drift out or press out old bearing

re-placing is the reverse procedure

re-tighten hub nut to specified torque

• 
• 1 answer

Lauren Hart is a professional recording artist.

• 
• 1 answer

Every time a wrong code is entered the wait time doubles, you must just sit the wait time out with ignition on & re-enter correct code ( various proceedures for various models) or try disconnecting battery for an hour or so....... Good luck :-)

• 
• 1 answer

i have a 1986 Toyota 4x4 auto 2h diesel with electric and hand crank if battery is flat it has a special radiotr with hole in it for crank handel

• 
• 1 answer

Landrover RAVE manual for Freelander Mk1 gives the following values:- Front disc brakes Front caliper mounting bolts 83 Nm Front disc to drive flange screws 5 Nm Front disc shield to hub screw 8.5 Nm Front caliper guide pin bolts 27 Nm Front caliper brake hose banjo bolt 28 Nm

• 
• 1 answer

range rover to the tune of 10,000 more

• 
• 1 answer

When Land Rovers were first built they were made my Rover, then British Leyland before being bought by British Aerospace. They then changed hands to BMW and then to Ford. In June 2008, Ford sold its Jaguar and Land Rover operations to Tata Motors, who currently own Land Rover.

• 
• 1 answer

i'm pretty sure that nearly ALL the FUSES are now inside ....next to the heater controls

• 
• 1 answer

if it is a 1.4 or 1.6 K series engine its underneath the inlet manifold towards the left hand side ( nearest the belts ) 2.0 T series engine - top left hand front of cylinder head

• 
• 1 answer

Under the bonnet. as you look at the front of the car it should be just behind the right hand light.

• 
• 1 answer

Range Rover 2003-2005 years.