if it is the ones with a metal clip the you would pry (lightly) on the middle of the plastic clip to work your screwdriver underneth the metal clip retainer..it slides out and releases the plug. to re-assemble simply slide the clip back in and re-install the plug.
To change the injectors on a 6.0 you must first 1. Remove the valve covers 2. Remove the high pressure oil rail. Be careful not to drop any bolts, not to break off the injector connectors, they break easily. 3. Remove the injector clips on the outside of the head, inboard towards the turbo. 4. unbolt the injector 5. Use an injector puller so that you dont damage the injector, or injector bore.
the part attached to the top of the fuel injector is called the fuel rail
Replace the clips.
The rear apron is interchangeable between those two years, the clips should be the same also.
Passenger's side of the engine compartment. Four clips hold the top of the airbox on and you can only lift it about 2" once the clips are off, just enough to get the filter out.
To replace the glove box handle on a VW Beetle, first, open the glove box and remove any contents. Then, locate the screws or clips securing the handle to the glove box door and remove them. Once the old handle is detached, position the new handle in place and secure it with the screws or clips. Finally, test the handle to ensure it operates smoothly before closing the glove box.
Squeaking usually caused by vibration Anti-rattle clips (if any) installed? A paste type compound is available to stop rattle
There are plastic clips that rotate on rear part of headlight under hood that release the assy then the whole thing slides forward out the front of car.
it is held on by a small clip you have to force it out ie pull on the handle, you need to get replacement clips from vw, i have the problem mine come lose rubbish design
Generally, you have at least 2 bearings, a compressor wheel, a turbine, a hardened shaft, 2 locks or clips to restrict moment, a compressor housing, a turbine housing, and bolts/nuts.
Use Snap Ring Pliers on the clips (3) - squeeze pliers closed and while clip is spread open pull up with needle nose pliers
Clips hold the door panel in place. To remove the panel, you will need a small pry bar and apply gentle pressure to the gap between the panel and the inner part of the door.