You would need to jack up the tire and remove it and take off the cap and remove the carter pin and reove the rotor and inside the rotor you will find the bearing. There will be two of them the inner bearing as well as the outer bearing. It's always good to change them both if you have the money to do so.
No it only has one wheelberring it is a pressin berring easyist way is to take the ball berrings out so you have just the race heat it up put i mini sledge aganst it and hit the mini sledge with another hammer
On a 1995 Mercury Mystique : There are ( 4 lugs for each wheel , total of 16 )
Yes it does. It has inner and outer bearings.
YES
In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.
You have to buy the wheel bearing assembly.
Front or Rear? Both
Wheel bearings on 1995 Geo Prizms are sealed units and cannot be repacked with grease. You must buy new bearings to be pressed on hubs by mechanic with proper tools. If bearings are worn, replace ASAP before bearings start damaging hubs, you'll save bunches of money.
don't you have a manual that can help us?
I have a 2011 650i and it costs 1300 its prolly about that...
Yes, this is the usual way.
Wheel bearings help your wheels to roll smooth and fast.
Cars have a total of four wheel bearings, one on each wheel. The wheel bearings are designed to help the wheels spin. Many cars have two wheel bearings per wheel, an inner and an outer located in each hub/bearing assembly.