answersLogoWhite

0

  • Headlights Tail and Brake Lights
  • Chrysler Sebring

How do you get to the brake light bulb on a 2002 Chrysler Sebring?


Top Answer
User Avatar
Wiki User
Answered 2009-09-02 19:46:49

peel back the trunk liner.....should be two or three screws. unscrew and pull the entire light assembly out its a pain in the but!

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Where is the brake light switch on a 2002 Chrysler sebring?

On a bracket, above the brake pedal.


Where is the stop light switch on a 2002 Chrysler sebring?

It is on a bracket, just above the brake pedal.


What kind of brake fluid for a 2002 Chrysler Sebring?

It uses DOT3.


Where is the cabin filter on a 2002 Chrysler Sebring?

A 2002 Chrysler Sebring was not built with a cabin filter.


Where is the maf sensor on a 2002 Chrysler Sebring convertible?

A 2002 Chrysler Sebring convertible does not have a maf sensor.


Is there a 2002 Chrysler cirrus?

No, in 2002 the Chrysler sedan was a Sebring.


Where does brake fluid go in a 2002 Chrysler sebring?

Far driver side of the firewall under the hood.


Where is the MAF Sensor located on a 2002 Chrysler sebring sedan lx?

A 2002 Chrysler Sebring sedan does not have a MAF sensor.


Oil pressure light in 2002 Chrysler Sebring 6-cylinder?

The 2002 Chrysler Sebring six-cylinder engine oil pressure light alerts the automobile operator when the oil pressure is too low. The oil pressure light will illuminate red.


How do you change the brake light on a 2002 Chrysler Sebring?

This is what I found for the 2006 Chrysler SEBRING center brake light. Expert: KevinDate: 2/23/2008Subject: 2006 Chrysler SEBRING center brake lightQuestionHow do you replace the center brake light inside the trunk lid?Vehicle handbook gives details of the older type - housed under the parcel shelf AnswerREMOVALDisconnect and isolate the battery negative cable.Remove fasteners from trunk latch cover by prying under the head of the fastener with a flat bladed tool.Remove trunk latch cover.Rotate socket counterclockwise one quarter turn.Pull socket from back of lamp.Pull bulb from socket. Link below: http://en.allexperts.com/q/Chrysler-Repair-807/2008/2/2006-Chrysler-SEBRING-center.htm


How to replace push rods on a 2002 Chrysler sebring gtc?

A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.


Where is the brake fluid reservoir on a 2002 Chrysler Sebring?

It is under the hood, driver side, up near the base of the windshield.


What engine will have the same wiring harness and motor mounts as the 2.7L out of a 2002 Chrysler Sebring?

The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.


Where is the brake light switch on a 2002 Chrysler 300m?

It is on a bracket just above the brake pedal.


Does a 2002 Chrysler sebring have a vacuum modulator?

No.


Does a 2002 Chrysler Sebring have a cabin filter?

No


Where is the obd connector on a 2002 Chrysler sebring?

The 2002 Chrysler Sebring OBD 2 port is underneath instrument panel, near steering column


What oil is needed for a 2002 Chrysler Sebring?

5w30


Where is the towing hook on a 2002 Chrysler Sebring?

It does not have one.


How do you reset the check engine light in a 2002 Chrysler sebring convertible?

You need a scan tool to properly reset the check engine light.


Why does the air bag light stay on in a 2002 Chrysler Sebring?

The airbag light stays on when the computer detects a malfunction and stores a trouble code.


Would the steering column out of a 2000 Chrysler cirrus interchange with a 2002 Chrysler Sebring?

No


What kind of transmission fluid for a 2002 Chrysler Sebring?

ATF4+


Will a 2002 2.7 fit in a 1998 Chrysler sebring convertible?

No.


Bolt pattern for 2002 chrysler sebring?

5*114.3