Headlights Tail and Brake Lights
Chevy Corsica
Toyota Sequoia
Ford F-250

How do you get to the tail light bulbs to change them in a 1996 Chevy Corsica?


Top Answer
User Avatar
Wiki User
2015-07-15 21:32:58
2015-07-15 21:32:58

On the 96 Corsica the tail lights, reverse lights, sidemarkers, and license plate lights are contained in one module. To remove the module, open the trunk and pull back the felt against the back. There should be three large plastic wingnuts and two small ones. Remove the three large wingnuts and pull the entire light module straight out from the rear of the car. The bulb sockets just twist and lock in place.

I recently changed tail light bulbs in 1994 Corsica there were plastic knob kind of nuts on the bolts inside the trunk about 6 to 8 of them, just remove them push out the bolts to open and replace the bulbs. I don't know if 1996 has a different kind of assembly.


Related Questions

User Avatar

you need to remove the taillight assembly. you will see all the bulbs.

User Avatar

Some bulbs can be changed by accessing them through the runk but I think your have got to remove the light assy and then remove the bulb.

User Avatar

how do I replace interior light bulbs in 2002 chevy impala. I removed the cover, but the bulb is cramped in and I can't pull it out.

User Avatar

Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.

User Avatar

Remove the two screws that hold the lens on, remove the lens and change the bulbs.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.