the only way you could probably do that is if you waste it like if is was gasoline
or you can use a tube and suck the water out
Yes, because water is heavier then gasoline
A tank which stores water, oil, gasoline, or air.
It is hard to know when you have water in your gas tank. However, that is no longer the problem that it used to be in the United States. Most of the gasoline in the United States contains alcohol. The alcohol makes the water mix with the gasoline. As water condenses in the gas tank it mixes with the gasoline and is removed in the engine exhaust.
Water is heavier than gasoline, it will pool at the lowest point of the fuel tank.
Gasoline does not freeze.But, it is common for there to be minimal amounts of water inside a fuel tank, and when there is not enough gasoline to dilute it, that small amount of water then can freeze.There are additives designed to deal with that water and prevent it from causing starting problems.
If it is a small amount of water add a can of Heet to the tank and fill it with gasoline. If it has allot of water you will need to pump all fuel out of the tank, add a can of Heet and fill the tank.
Gasoline being poured into a tank is not a chemical change.
To calculate the weight of gasoline in a tank, you would need to know the volume of gasoline in the tank and its density. Multiply the volume by the density to get the weight. The density of gasoline can vary depending on factors such as temperature and composition.
You will need to empty the tank while hooked to the car. (so when you do drop the tank you dont get splashed with gas to much. when the tank is removed you will need toFlush out the Contents: Empty the tank of all its contentsClean the Tank: Use new gasoline and clean the tank thoroughly.Hot Water and Acid Cleaning: Now is the real cleaning step. You will need hot water as much as the capacity of the fuel tank. Fill the tank to half its capacity with hot water. Remember the muriatic acid we just spoke about? Its time to add it to the hot water. You will have to add approximately half a gallon of the acid to the water. Then add in the remaining hot water in the tank. Close the gas tank with a cap, but make sure you do not use the tank cap. Do not disturb the tank for about 2 to 21/2 hours. Let the entire mixture settle in the tank.Dispose off the Mixture: Empty the gasoline tank of the mixture. The mixture contains muriatic acid, hence, be careful while doing so. It is suggested not to dispose off the mixture down a drain or in the dustbin.Clean with Water: Now clean the tank with water thoroughly. You can use a hand pump to spray water in the tank. The pressure of the hand pump will reach to every nook and corner of the tank, thus cleaning it in the process. There can be several rounds of cleaning with water.Dry the Tank: The next step is to dry the tank well. You can use a hair dryer for the same. It means a lot of work. But if you leave the tank to dry on its own, it will take longer. You can use the hair dryer to dry the tank, as the warm air will reach well inside the tank. This is an important step, as gasoline will be filled in the tank soon afterwards.Gasoline Rinsing: After you have dried the tank, rinse the tank well with gasoline. This is the last step in the gasoline tank cleaning procedure.Fill gasoline in the tank: Attach all the components, which you have removed in the first step. Keep a small quantity of gasoline ready, so that the vehicle reaches the gasoline pump station. Now, do not waste any time and refill the tank back with gasoline. It is important to refill immediately, as the tank can start rusting again.
.0003 cm
water can be pumped in from a leaking underground tank at a gas station or if you leave your gas tank only partially full and the temperature shanges it can cause condensation inside your tank
50 ml