answersLogoWhite
Starters and Ignition Systems
Nissan
Chevy Blazer
Kia Spectra

How do you get your keys out of the ignition if they are stuck?

151617

Top Answer
User Avatar
Wiki User
Answered 2012-10-20 14:39:02

Try to put it in nutral and shift back into park again. Make sure your steering wheel is in the straight position. Sometimes the wheel will lock if it is turned. Hope this helps.

Sometimes the locking tab that holds the little button you press on the shifter breaks and doesn't allow the electrical system to see that the car is in park which

will not let you remove the key or start the car.

Pull the plastic button out just a bit or all the way off if it's broken, and that will engage the park signal and get you on your way. Ford won't take this as a safety recall. Been there before.

Magiver.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


Key is stuck in ingnition


may be button on gear handle is stacked, check position of button, release it fully.


Lost ignition keys for newer vehicles can be obtained from the vehicle dealership. Lost keys for a 1978 Honda Accord will require the replacement of the ignition.


They do have ignition keys. You must have the key on your person for the start button to work.


Why won't the keys in the ignition turn on a 1992 grand marquis?


how to remove key stuck in ignition switch in Chevy colbalt


Yes, originally the door and ignition keys are the same. but if you have to replace your ignition / steering column, you will have a different (re-keyed) key for the door and for the ignition.


You do not need a key to replace the ignition switch.


There is an access cover just under the ignition cylinder. Remove this to remove the stuck key.




Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?


Keys are not necessary, but is not a DIY procedure. Contact a locksmith or mechanic


Not the starter, but the weight of the keys can be damaging to the ignition key cylinder.



There should be a lock on the ignition a push button that you push and turn to remove the key


you will have to replace the complete ignition switch with a new one.


The security light comes on after you changed the keys in the ignition from the off position to the on position as a confirmation that the electrical components in the dash board are working. It is nothing to be concerned about.



Good question. If it is stuck because you spilled water or something on it, turn it upside down and let it dry out. That usually works for me, but this time two keys remained stuck, and it was only water. The rest of the keys recovered.


one with the doors unlocked and the keys in the ignition



Not from the factory , just the one key works for the door and ignition


Your factory ignition keys are embedded with a transponder that must be programed to the vehicles ignition system. It can be done by the attentive home mechanic by purchasing the keys for $80 to $100 and following the programming procedures.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.