Want this question answered?
hook a ground up to your battery and mount it to the amp and hook it up with a few more things and yea you got it man
yes but u would have to hook the amp up to a power source and ground it
yes you can i have an amp and subs in my 2006 dodge 2500 HD
You have to employ the microphone jack on the amplifier providing the signal to the speakers. If you don't have a mic jack on your amp, your out of luck.
Yes you would hook the audio line into the amp then to the speaker from there.
ONLY if your amp can pull a 2 ohm load! Which is vary few but your more expensive amp can pull 1/2 ohm load
the best way is to hide all your wire so it looks good nd if u have a truck put your amp under the seat and cut ur wires just enought to hook up into the amp and subs nd thats the best way
You connect the mixers main outputs to the inputs of the amplifier and the outputs of the amplifier to speakers
you need an amplifier first. decide where you want the amp, and wire it to that point. (amp comes with instructions for the wiring) once the amp is wired in, wire it to the radio(instructions come with amp) and screw it in. then locate where you want the sub(s) and wire it to that from the amp. almost all your instructions for installing subwoofers comes with the amp.
Hook your speakers up to the amp.
yes, you can, either via a Y-cable to the sub output, or via a pre-amp, or hook them up parallel to a mono amp or if you have a 2 channel amp then just hook them up regurally but if you have a mono amp then...have two positive and two negative wires coming out of the amp then hook 1 negative wire up to the negative spot on a speaker..then do the same with the other..then do the same with the positive
The amp for audio freq. is a AF amplifier. The RF amp is for radio freqs.