0
I,ll figure u have no idea how the motor works. That,s how I started. The ignition has a coil and points. There is a central contact for the points and coil. U have to connect a ground wire to this point so when the motor is running and u ground that point it kills the motor. Any questions e-mail me!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Will a loose kill switch wire on a out board motor cause bogging down?
A loose kill switch wire on your out board motor will cause the engine to lose power. As the kill switch loses contact the motor will begin to bog down or completely quit.
What is button on tiller for on j15rcud Johnson 15hp outboard motor?
It is the kill switch
By pass a kill switch on a gy6 scooter motor?
Isolate the wire going into kill switch [wrap some tape round it] so it cannot be earthed.
What does a kill switch look like?
A kill switch is usually nothing more than a common toggle switch. It is usually installed in a hidden place and is used to disrupt electrical power to the starter motor.
How do you turn a motor bike of?
Hit the kill switch or release the clutch with the throttle closed
How do you reset oil change button on suzuki df40?
Change oil. Turn motor ignition switch to on but don't start Pull off emergency kill switch plate Pull emergency kill switch 3 times in less than 7 seconds. Replace kill switch plate. Done.
How do use disable in a sentence?
A kill switch is used to disable the motor of a jet-ski if the rider falls off.
How do you deactivate the kill switch in a 1998 Chrysler Sebring?
It does not have a kill switch.It does not have a kill switch.
Why doesn't my Mercury Tracker 25hp Outboard Motor start?
If not getting spark push the kill switch on the the lanyured and should start but if you left fuel in it the fuel might be bad so clean that out first then push the kill switch DON'T BUY NEW COILS BECAUSE IF JUST MIGHT BE THE KILL SWITCH
How does a kill switch work?
The KILL switch is in series with the ignition switch. When the KILL switch is open, the bike will not start.
How do you pull out the kill switch in a Chrysler 2004 Sebring sedan?
Chrysler does not have a kill switchChrysler does not have a kill switch
What would make your bike stop running when you put it in gear?
if the kickstand is down, the safety switch will kill motor. or it may be defected.
