0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why would the cooling fans on a 91 Honda prelude si not come on?
id have to look to see why but what you can do is get new fans and hook it up to a toggle switch. when you hook the toggle switch up just flip the switch before it gets too hot
How do i wire a toggle switch for an amp?
Hook a switch up to the remote turn on and ground. Before the wiring for the amp.
How do you wire a rocker switch to radiator fan on a Grand Am?
to shut the fans on and off by yourself. remove the connector for the wires at the fan. hook a wire from the positive on fan motor to the inside toggle switch, do not hook to switch yet. run a wire from the positive on battery, hook to battery after hooking up switch. hook up the wires to the switch. then the battery. its up to you if you want to install a 15 amp fuse in line from battery to toggle switch.. you can also get the power from the fuse box instead of the battery. this should work for you. if not you may need to ground the other fan wire.
How do you make bypass for vrx485vd clarion?
go to your local parts store and purchase a simple toggle switch. hook one end of the switch to a good ground and hook the wire for the parking brake from the radio to the switch. when you insert a DVD and get the blue screen turn the switch on then off then on again slowly and you will have video
Can you hook up your headlights to a toggle switch?
Yes, its not like your cars gonna blow up. Check with a local Mechanic before you do it. Love, Marybeth
How do you hook up a toggle switch on speakers?
I have the same question, I'm thinking about using electrical wire and switches to create a 3-way speaker system...
How do you bypass parking brake wire on a clarion vrx485vd?
you have to hook it up to a basic toggle switch and ground it and when you turn it on you have to flip the switch a couple times,... you cant just ground it or it will show the blue screen
How do you by pass cooling fans relays and use a toggle switch?
Take the 2 wires on the relay off and run each into the interior of the car where a suitable switch can be installed. Take the 2 leads and hook them onto the switch. Make sure you have an inline 30 amp fuse installed.
What are the 10 kinds of fastening?
toggle button frogs hook & eye laces buckle zipper velcro high studs (as in hunting boots) lock-clasps (as in old fashioned goulashes, or rain boots)
Changed the car battery in Toyota rav4 alarm would not stop do not have alarm remote?
there is a reset button by the hood release but on the left side when you are sitting in the drivers seat. hold the button while turning the key. -----August 25, 2011 First of all, thank you. I followed the advice above. Yes there is a toggle switch next to the hood release. I also lost my remote for the alarm and when I replaced the battery the alarm went off. I followed the advice as soon as I hook up the battery, with the key in the ignition (ON) setting I flip the toggle switch a few times. This enabled to reset the alarm and I was able to start the car.
How do you hook up switch leg?
diagram to hook up switch leg
What 2 color wires do you need to put a simple push button starter in and do you tie into those 2 wires or cut them and go directly to your button?
Find the wire that becomes energized when you turn the key switch to start, that will be the wire that you need to hook up the "normally open", push button switch!
