0
to shut the fans on and off by yourself. remove the connector for the wires at the fan. hook a wire from the positive on fan motor to the inside toggle switch, do not hook to switch yet. run a wire from the positive on battery, hook to battery after hooking up switch. hook up the wires to the switch. then the battery. its up to you if you want to install a 15 amp fuse in line from battery to toggle switch.. you can also get the power from the fuse box instead of the battery. this should work for you. if not you may need to ground the other fan wire.
What else can I help you with?
How to turn on my head light and tail lights with no switch?
For Temporary Fix, By A Rocker Switch From Auto Parts Store. Pull Your Head Light Switch Out Of The Dash Wire In The Rocker Switch. Will Have To Find Wiring Diagram Or Chiltons Book For Wiring Schematic For That Year Of Vehicle. Only Temp Fix, Should Replace With Stock Switch For That Vehicle.
Where is Fan relay switch 99 vw passat?
It is mounted in the radiator, and is a thermostatic switch. It is located in the top left side near the fan itself. It is the only wired device in the radiator, so if you can see the wire, you got the switch.
How do you properly wire a 3 way rocker switch for optimal functionality?
To properly wire a 3-way rocker switch for optimal functionality, you need to connect the power source to the common terminal, and the two other terminals to the two separate light fixtures. This allows you to control the lights from two different switches. Make sure to follow the specific wiring diagram for the switch you are using to ensure correct installation.
Where is the switch that activates the back-up lights on a 1996 Grand Cherokee?
It is a three wire switch on the driver side of the transmission.
Where is the Neutral Safety Switch on a 1991 Ford Escort?
The safety switch is located under the radiator belt. You can trace the positive wire from the battery and it will end up at the safety switch.
Where is the backup light switch on an Acura Integra?
it is under the transmission. u can see part of the wire when you are looking into the engine bay. the wire should be close to the radiator.
How do you wire up radiator fan?
To wire up a radiator fan, first ensure the vehicle is off and the battery is disconnected. Connect the positive wire of the fan to the positive terminal of the battery or to the ignition switch for operation when the engine is running. Then, connect the negative wire to a suitable ground point on the vehicle. Finally, if applicable, connect a relay or temperature switch to control when the fan activates based on engine temperature.
Your Renault 5 engine fan isn't kicking in Any idea why?
Dead fan motor, bad connetion to fan motor, faulty swith on radiator. To check, pull connetion to fan apart, this is a two spade connection found close to fan. Run a live wire from battery to connection and another wire from connection to negative pole on battery. If fan starts to spin, the motor is fine. This test can also be done at the thermostat switch on the radiator. Fault must be at radiator switch. This switch is located half way down the right hand side of the radiator. Drain radiator, remove switch, replace switch, refill radiator, bleed cooling system. Problem solved.
Testing a radiator fan switch acura tl?
1. Locate and unplug the radiator fan switch A. This is in the area under the air passage the leads between the air filter and the upper intake manifold. It is located next to the right-most coolant passage (look for the two large radiator hoses, it's the lower hose.) The connector is round and gray and has one black wire and one green wire leading into it. 2. Turn the car to the on (II) position. 3. Use a multimeter to measure the voltage between the connector for the green wire and any unpainted bolt that is clearly attached to the body of the car (like the bolt head of the right 3 suspension tower connectors). Is there battery voltage? (approx 10-12 volts) Yes- go to step 5 No- repair open in the wire between the radiator fan switch A and the under-hood fuse/relay box (black box near passenger windshield). 5. Turn the ignition off and use the multimeter to check for continuity between the black wire of the radiator fan switch A and body ground. Is there continuity? Yes- replace radiator fan switch A No- check for an open in the wire between the radiator fan switch A and the body ground
How does the rad fan on a 1986 Honda Prelude come on?
There is a temperature switch on the passenger side bottom of the radiator that has a wire connector attached to it. The switch screws into the radiator and then the wires connect to that. That switch is what tells the relays to turn the cooling fan on. If your fans don't turn and the engine is running hot you can test the switch using the following steps. 1. turn the ignition to the on position but don't start the engine. 2. disconnect the wire connector to the switch on the bottom of the radiator. 3. using a small jumper wire, jump the two wires inside the connector. If the fans turn on then you will need to replace the temp switch. If the fans still don't turn on then you will need to check the fuses, relays, and the fans themselves.
Where may you find the switch for the fan on the radiator of your 1997 1.5 323 would it be elsewhere if not on radiator possibly?
on the engine block on the thermostat housing the water thermosensor have 1 wire to it FOU on the engine block on the thermostat housing the water thermosensor have 1 wire to it FOU
Where is the auxiliary fan switch on a 1999 Volkswagen Jetta?
Drivers side of the radiator, down towards the bottom. It will have a three wire plug on the end.
