need a diagram for mcculloch eager beaver chain saw
How to hook up fuel lines to petcock on 98 gsx 600
You will need to drop the gas tank, unhook the fuel lines, and replace the old fuel pump with a new one and hook back up the fuel lines.
fuel line routing on 1979 Yamaha xs1100
it is located in the tank but you can get to it without dropping the tank. It is located top side..look for the fuel lines...and do you know how to hook up the vacuum lines on that same truck? or can you send me a picture of them?
fuel pressure regulator
the fuel filter is located under the trunk, next to the fuel tank, it just takes the quick release tools to un hook the ends. it has three fuel lines on it.
It is located on the passenger side below the carburator.It should be white in color with two fuel lines going to it and is held in place with a metal clip assembly.It sits right over the right side inner fender.Note before you replace the filter the hose hook up the filter may or may not have a arrow on it indicating the flow of fuel being from the tank to the fuel pump.Most new filters have the arrow and if you do hook up the two lines wrong the truck will run out of fuel to the pump and you would simply change the lines to the opposing ends to correct the installation.I would look at the fuel lines and see which fuel line goes to the pump and which line is coming from underneath the cab if you have not done this to avoid any problems.
I'm having the same problem with my Poulan chainsaw and weed eater. I think the line starts with the fuel filter in the tank and travels up to the primer bulb, out of the bulb into the carburetor, and out of the carburetor back to the tank. Whatever the size of line is that hooks to the fuel filter is what will hook to the primer bulb and then the carburetor. Then one more single line returns to the tank. I may not be correct on this, but there's not much information available. The diagram on Poulan's website does not show the routing of the fuel lines. that is right but to remove the main line you need to drain fuel and pull the line out from the fuel tank neck first because it has a connection that will not fit threw the hole in top. to replace it cut new line at a slaint and fir it threw from the top down into the fuel tank. then keep it long and pull out enough threw the fuel cap to put fitting back on it and fuel filter then pull it back threw and hook it to primer bubble. Not sure about your answer I have two different size fuel lines on mine. The larger line if I remember correctly runs from primer bulb to the right of fuel tank where the larger opening is located. The smaller line is where I am confused at shouldn't the smaller line from the fuel tank that has in tank filter attached run up to carburetor. then a smaller line from primer bulb to second fitting on carb. byrumjr the line starts with the fuel filter in the tank and travels up to the carburetor out of the carburetor into the primer bulb, out of the primer bulb back in the tank
take the fuel lines off of the pump and take the 2 bolts out that hold it on and pull it off, to reinstall there is a pushrod inside the engine that rides on the pump arm, you have to push the rod back up out of the way and quickly insert the pump in place and reinstall the 2 bolts and then hook up your fuel lines to the pump and your done.
This is very easy. Jack up the front passenger side. Put a jackstand in the correct place. If this is a small block, the fuel pump is under the alternator. There are 2 bolts holding it to the block and 2 lines, 1 going into it, 1 going out. Un hook the lines (One will be rubber, it should be replaced). Then put the new pump in, and hook it all back up in the opposite order. Its pretty straightforward.
you hook up a fuel pressure guage to it to check the fuel pressure
The fuel level gauge is in the tank