Not that hard you will need a power distribution block this splits your main power wire. One in and 2 out just hook up each amp power to any of the 2 empty spots on the distribution block.
Preferably with a multimeter. For amps you hook it up in series, for volts you hook it up in parallell. For Ohms, you'll need to have the item you want to measure separated fron the circuit.
Preferably with a multimeter. For amps you hook it up in series, for volts you hook it up in parallell. For Ohms, you'll need to have the item you want to measure separated fron the circuit.
If the voltage is right for the bulbs, you can hook up 600 amps divded by the amps taken by one bulb - that gives the number of bulbs. But 600 amp needs very thick wire.
You'll have to hook them up Parallel to each other electronically. It would be easier with just one amp, unless you are doing the bass with one and the rest of the frequency spectrum with the other which in that case they do not need to be tied together.
Yes you can hook up a car subwoofer to a dj amp. Some dj amps have a barewire hook up on them so you can hook it up using the same wires as you would with your car amp. If not then you would have to either convert your hook up on the speaker box to the style in which your amp takes, or splice new ends onto your existing wires to hook up to the amp. The one thing to watch out for is your rms and peak power. Dj amps tend to be a bit more powerful then car amps and you can cause damage to your speaker and or amp by forcing to much power, or by giving to little power. I suggest trying it out at home for a good amount of time on a med. power level to see if the amp and speaker can hold to a couple hours of non stop use before I would take it to a gig with me.
why cant you hook a toner up to a two way spliter?
Hook up can mean several things. For example. Hook up could mean that you ran into an old friend and the two of you hooked up for the night. It could also mean that you are going to hook something on a wall and off the floor where it's in the way all the time. It could also mean that you met a lady or a lady met a man and the two of them hooked up for the evening or night.AnswerConnect or link up.
yes i had three different kinds in my truck just make sure before you hook anything up that your amps are not draining your battery....that results in dead alternator
Be sure you discharge cap before installing new amp.
No. If device draws 200 amps breaker will trip.
You would bridge the amps, it will cut into your power, but that's how you do it. This is not recommended because you take a pretty big risk of blowing both of your amps. .-Shocker
If you connect two 8 ohm speakers to the average car amp, then yes, probably. Most car amps can handle a 4 ohm load, which is what it would be.