answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you hotwire 2000 olds silhouette?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What cylinder heads will fit a 2003 olds silhouette?

what heads will fit on my 2000 olds silhouette v6 3.4


What type of freon does a 2000 olds silhouette use?

My 2000 uses 134A and looks stock...


How do you reset the message center on a 2000 Oldsmobile silhouette?

all the messages are showing up on my 2000 olds silhoutte, why does it do this


Where the fuel pump reset switch on a 2000 olds silhouette van?

Gm vehicles do not use inertia/reset switches.


What is the firing order 2000 olds silhouette?

1-2-3-4-5-6 Click the link for a diagram.


Where is the catalytic converter located on a 2000 olds silhouette?

Crawl under the car and look up at the exhaust system. You will see the converter.


How do you program interior lights 2003 olds silhouette?

how to get the interior lights to turn on on 2003 oldsmobile silhouette


Where are the 1993 silhouette diagnostic codes?

read my answer to reseting engine codes below...2001 olds silhouette..


Is there a circuit breaker that controls the tail lightsheadlights and the backlights in the dash of a 1999 olds silhouette?

Is there a circuit breaker that controls the tail lightsheadlights and the backlights in the dash of a 1999 olds silhouette backlights in the dash of a 1999 olds silhouette i have a short in both tail light both burn out ? what can i do to fix it thanks Lloyd


Obd not communicating with scanner on 2000 olds silhouette?

If you're sure you've got the correct scanner and using it correctly then it is highly probably you have a bad ECM.


How critical is a P0135 diagnostic code for an 2002 olds silhouette?

=== ===


How do you change an alternator in a 2000 olds silhouette?

Remove the alternator belt on your 2000 Oldsmobile. Disconnect the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Put the new alternator on and reverse the process.