I dont know, but if u want like the little batteries to last a bit longer or if they go dead, warm them up under ur butt (hehe) or between ur hands and put them back in the device and they start to work! But only for a short period of time
Voltage
Your car has a 12 volt system and uses a battery to maintain that 12volts. However cars us an alternator to produce power to charge your battery (at a slightly higher voltage, usually 13.8 volts). However if the engine is running slower, the alternator stops charging the battery and your system goes back to it's 12 volt battery power and therfore 1.8 volts less. All the lights dim slightly, the heater will slow down, everything that uses electricity will be effected. A weak alternator will make this worse as does a worn, slipping alternator drive belt. Should probably be checked.
The number of amperes is unrelated to the voltage. The maximum amount of current (in amperes) that you can take from the battery depends on the exact build of the battery.
the main point is that.... by increasing of voltage the current will be increase...not by increasing of current voltage is increase....in that way we write that V is directly proportional to I...
If we increase the voltage by adding extra cells or batteries we give the electrical charges more energy and so, the current flowing around the circuit increases.
To increase voltage output when using more then one battery connect the batteries in series.
The power in the circuit will increase.
It should decrease
Ohm's Law states that Voltage = Resistance (Ohms) * Current (Ampere). So when you increase voltage, you increase current.
When the alternator starts charging the battery voltage will increase about two volts to charge the battery.
If the 2nd battery is connected "in series" with the 1st battery, the voltage will increase & the motor will run faster. If the 2nd battery is connected "in parallel" with the 1st battery, the voltage will not change, but the total battery capacity will be greater & therefore battery life will be longer than when using just 1 battery.
Battery fails to charge, alt light comes on, sometimes only at low revs. Check with meter shows low or no charging voltage (close to or less than battery voltage) voltage does not increase to charging volts with engine revs increase
You would have to apply a higher voltage from outside - for example, in the case of DC, connect a battery that provides more voltage, or connect more than one battery in series; or in the case of AC, use a transformer to increase the voltage.
The current in a circuit, expressed in milliamperes, is1,000 x (battery or power supply voltage)/(resistance connected between the power supply terminals)If you increase the voltage of the battery or power supply, the current in the circuitincreases proportionally, at least until something in the circuit gets hot, melts, fuses,and opens the circuit.
Yes.If you connect the batteries in series the total voltage will be the sum of the voltages of the batteries.For example if you connect a 12 volt battery in series with a 6 volt battery the total voltage will be 18 volts.
Series.
Adding a seound battery to a series circuit will increase the voltage, and require less current to keep the lights (if there are any on) as bright. Say you have a 6v battery, then you add another 6v battery. the voltage of the circuit would be 12v