0
How do you initialize the ignition control unit in a 1986 Volvo 240dl?
Updated: 10/22/2022
Wiki User
∙ 11y agoBest Answer
Simply switch on the key to initialize and crank the engine to activate. What kind of problem are you having to ask this type question?
Wiki User
∙ 11y agoThis answer is:
Add your answer:
Earn +20 ptsQ: How do you initialize the ignition control unit in a 1986 Volvo 240dl?
Write your answer...
Submit
Still have questions?
Related questions
Diagram for firing sequence of an 1989 Volvo 240dl?
2431
Where is the starter inhibitor switch on a 1990 Volvo 240dl?
Where is the starter inhibitor swith on a volvo 1993 260 GLE i ?
Where is the starter relay located on a 1986 Volvo 240dl?
I believe there isn't one.
Does an 1984 Volvo 240dl have an integal regulator?
My 1982 Volvo 244GL had a voltage regulator in the back of the alternator so I assume your 1984 is the same
Where is the fuel pump located on a 1988 240DL Volvo?
Why does my car kick over but wont start?
Does a 1990 Volvo 240DL use a 1 wire alternator for a 12 volt system?
mikehunt
Is synthetic 5W30 the best engine oil to use for your Volvo 240DL?
Best is what the manufacturer recommends.
Where is the temperature sending unit located on Volvo 240DL?
on left rear side of engine block
What size wrench to remove Volvo 240DL oil plug?
7/8 Inch Socket:
What are the 4 round black things that touch the ground on my 1989 Volvo 240DL with the M47 transmission?
Tires?
What type of brake fluid is used in a 1981 Volvo 240DL?
DOT ( 4 ) brake fluid , according to my Chilton Volvo ( 1970 - 83 ) repair book
Where is the oil drain plug on a 92 Volvo 240DL?
The plug will be a giant 25mm bolt right on the bottom of the oilpan.
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.