You must first split the case after draining the oil of course then pull the cam out being careful of your lifters not to fall out if they do just put them back in . . . now when you go to put the new cam in there is a dot on the camshaft and the crankshaft that has to be lined up in order for you engine to be in time. Make sure to line those up when you put the new cam in and you will most likely have to replace the crankcase gasket before putting it back together unless you managed not to rip the gasket when you split the case. After you put it back together put oil back in it normally around 1 quart and then you are good to go.
how to Change oil on a Briggs and Stratton 6.75 HP
were can i find a wiring diagram for a 18 hp briggs and stratton engine
12.5 hp Briggs And Stratton blows fuse when u crank it
220 in-lbs
Yes! The motor says its 12.5 hp but that's b.s it's the exact same thing as an 11hp Briggs and Stratton, cept they have a different style carb
15 HP.
0.030 is the gap for briggs and stratton 4.5 hp mower
Roughly 16.5 HP
How do I change points to electronic ignition on a 5 hp briggs & stratton small engine?
I have been told yes. My son said he uses it on his 21 hp Briggs and Stratton.
Briggs & Stratton part # 491056 NAPA filter # 1348
Brigg's and stratton 5.5 hp on the craftsman push mower your gap tool set the gap at .025-030 for briggs 5 hp