The angle senor is located on the passenger side of the motor,so if you open the ood and look to your left you will see a thing that loks like a distributor housing,it require a 12mm socket take the bracket of thr throotle bodt and the one bolt to he right of the hosing,undo the 4 prong plug give the housing a tap and it will come out,to install it just make ure the haft on the end of the houing fits in properly and bigo....
The crank positioning sensor is located on the opposite side of the block as the timing belt.
crank sensor also check cam angle sensor
if it has no spark and no gas its your cam angle sensor
It would be best if you let a pro install it as every crank has to be lined up for proper timing.
crank position sensor
Where is the speed sensor on 1998 eagle talon 5 speed
Autozone has a free online manual for the Eclipse.
on the throttle body.
Camshaft angle sensor (CAS) is on the head opposite of the timing belt. A 95 also has a crankshaft position sensor and that is down below the timing belt. 1G's only had one sensor to do the job of both and 95 and later have two sensors to send info to the PCM.
You stick it on the front with gorilla glue or some other strong adhesive. Never install a small talon though, because some people say it is bad luck or you have a small penis. The Talon must be at 6 inches long for you to show it off to everyone.
It's on the intake manifold.
Get pb-blaster, it's like wd-40 but better, spray sensor where it goes into exhaust pipe. Allow it to sit in for a little while and use either a O2 sensor socket, crows foot or flared end wrench to loosen the sensor. Then just unplug, put anti-seize on threads of new sensor and install