the front wheels have no bearings
Take the old dispstick out (if you still have it), take the new dipstick out of the packaging, put the new dipstick where the old dipstick went....
Equivalent material e36
how to remove broken dipstick tube ford winstar
lube the end of the dipstick and use a rubber hammer and pound it down into the oil pan.
yes whit no problemos
i think e36 engines were from 1991 - 1999
I is a bit different on some models (4 cyl VS 6 cyl) , but in the back of the engine there is a Red pulley on the drivers side right next to the intake manifold. That is the dipstick. Look in upper right of the engine bay in this photo: http://images.europeancarweb.com/features/0506_02z+1992_BMW_E36_325_4_Door+Underhood_M3_Supercharged_Engine.jpg
If your 325i is m50 and the m3 head is m50 it will fit. Or if both is m52.
If you have a transmission "Dipstick" which most cars do, you can slowly poor the tranny fuid in there (using a funnel) until it is at the appropriate level.(The dipstick will look a lot like your oil dipstick under your hood)
a side from performance air filter and a bigger exhaist what else can be done to increase power on the e36? excluding chip
To add fluid you add it through the dipstick tube