A double action hinge is really no different that a regular one. Simply place where desired, mortise them in and install. If it is confusing, look at it as if it was only opening one way at a time. One direction it uses the outside part of the hinge and for the other direction it uses the inside part. As long as you install each hinge on the same edge or in the same direction they work the same as a regular hinge. You are limited as to the thickness of the door you are using and there can not be any door stop as the door must swing both ways.
But there is a floor mounted double acting hinge that does require a little bit of preparation before installing: http://floorhinge.doorlocksanddeadbolts.com/
If the doors that you are installing these hinges on is a double door you need six double acting spring hinges to do the job.
1. Hang one of the hinges 3" from the top of the door.
2.The next hinges must hang 2"-3" from the first top hinges.
3.Then hang the final spring hinges 4"-5" from the bottom of the door.
This step work for double swing doors or single doors.
Spring hinges close doors automatically.
installing a double action spring hing
Read the instructions first. It is difficult to fug up this job because you can install them backwards or upside down. Take a good look at them and learn how they work,
Double action hinges are used to allow a door to open in both directions like the old saloon doors of the wild west days. You will also see this type hinge on the doors leading into kitchens in restaurants so that the wait staff can go through it in either direction because they always have their hands full and need that type of door to make their job easier. This hinge can be spring loaded so that it returns to the closed postion.
You can buy spring loaded hinges that will correct that problem.
Rear Multi-leaf springs with stabilizer Spring mounting with cushion stops Axle-mounting with v-stay and reaction rods Double-action shock absorbers No. of leaves 11 Spring length 1620 mm Spring width 90 mm
How do you install a cluch pedal spring on a 93 honda accord
The Double Dream of Spring was created in 1915.
The Spring Double in Horse Racing is the Grand National & the Lincoln
you unscrew the door hinges from the spring and it should slide right off
Difficult job to do in your driveway. The original hinges are welded in place both on the door and the cab pillar. The welds have to be drilled out and the new hinges are bolted in. The alignment is critical. The upper hinge halfs on the body side require removal of the dash assembly. There are kits available to rebuild your old hinges while in place. The kit comes with new pins and bushings. Either way you will need a door spring compressor to remove and replace the door spring. This tool is inexpensive and can be purchased from your local auto parts store for under $20.
123456