How do you install a driver side window motor on a 2001 Chevy suburban?

Answer 1

I have not yet replaced a window motor in a 2001 Suburban (fingers crossed since I own one!), but I have in other vehicles. It's a pain, but if you have skinny arms it wouldn't be too bad. :) First off, you will need to remove any screws in the door panel you can find (be sure to check in the door handle and look for caps that may be hiding screws). Next you will need to pop the body tabs that hold the panel to the metal of the door. Most parts stores carry tools for this so that you can save the tabs. They also sell the replacement tabs if you break one. Be careful pulling the panel away from the door since there are wires for the controls of the window attached. I removed the wire harness from the controls when I did it last so I could put the panel to the side and out of the way. Next, you will need to remove the vapor/dust barrier, which is just a sheet of plastic that is glued to the door to keep dust and moisture out. Once you have that pulled out of the way, you should be able to locate the motor inside the door, usually towards the bottom. There will most likely be a cable attached to it that is used to move the window up and down. Make sure that the cable is not the problem, it could be stuck, broken, or just off the pulley. If that is not the problem, then you will have to remove the bolts or screws that hold the motor in place, remove the cable and wiring and reverse to put it all back together.

Good luck!