Want this question answered?
Fuse, wiring, connector, drivers side window control switch.
under the back seat
mine on my 97 is on the rear window deck.
you need to change the window regulator
under the seat in the fuse box it should be the fuse directly above the window relay
You have to remove the door panel and attach the new window to the window frame this is very easy but it is time consuming and make sure you have no air leaks before you put the door panel back on
the window regulater has a nylon tape that runs the window up and down. the tape can be purchased fromm the parts store
turn bolts to the left, install regulator, turn bolts to the right
Start by disconnecting the negative battery cable, battery is under the rear seat. then remove all fasteners to the door panel,the panel slides up. Remove the plastic protector and remove the bolts that hold the regulator/motor then replace and reverse the order to install.
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
A crossed ignition wire and a power window wire could cause this problem. Check the wiring below the dashboard. You should be able to find the bared wires.
i need a diagram to install a window motor on a 1980 gmc truck