1995 2.2L Chevy Berreta/Corsica Serpentine belt replacement procedure without a diagram.
If it is a 2.2L (I have a 95 Berretta and the procedure is identical, as a matter of fact my user guides title is "1995 Corsica/Berreta", read below:
There was no belt routing diagram in the manual or under the hood so if the belt is still on make a quick but accurate sketch, this will save valuable time when it is time to replace the belt.
The auto-tensioner is located about 5-6 inches from the altenator, down and to the left if standing on the passenger side of the vehicle looking into the engine bay.
I used a 9/16 closed end wrech to loosen the tension on the belt. Pull up to loosen. Push down to tighten (right to tighten, left to loosen)
Removed the serpentine belt and replaced w/ the new one.
Route the belt exactly as in your sketch/diagram placing the belt onto the tensioner last. Tighten the auto tensioner bolt. Good luck... .
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
how do you install a serpentine belt on a 1996 corsica?
How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.
Replace serpentine belt on Chevy avalanche?HOW
Look at the pulleys on your accessories. it's that rubber loop going around all.
how to install a serpentine belt on 1989 f250 diesel 7.3l
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
there is a tensionor pulley that must be loosened using a 5/8 wrencth. wolverine
ther is a tesionor pulley that releives pressure to the belt. it should take a 5/8 wrench
The drivebelt routing decal on the radiator shroud to help during drivebelt install
serpentine belt for 97 7.4 454 Chevy truck