i just did a transmission change on a 90 s10 u probably have to drop gravel guard on transmission and starter should have two long bolts remove those and wiggle the starter out then carefully unbolt the two wires on the coil of the starter and be careful s10's usually have the two transmission lines in the way and those are a pain to replace hopes this helps and careful starter is heavy and u will prolly have to jack the vehicle up
the starter relay.
It is attached to the starter.
The starter solenoid is attached to the starter.
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
YES.
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
The starter solenoid is attached to the starter.
If you have the 4.3 L engine, no.
Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck
Follow the positive battery cable from the battery, it will lead you right to the starter.
On the passenger side of the engine in the back.
how do install key ignition switch 1988 Chevy s10