On the 3.5L The thermostat is actually part of the water neck on the front of the motor. Passenger side on the front. Follow the radiator hose to the engine. Where it goes into the engine is the water neck. It is all one piece.
The labor time to replace a thermostat on your 2000 Olds Intrigue, is about one hour. How much it costs depends on the Hourly Shop Rate at the repair facility that you select. Just ask them what their hourly rate is & that will also be your labor expense. Also, cost of the thermostat, around $15.00.
Only the Olds Intrigue with the 3.5 L
Need clarification on what you are asking.
Dealerships or junkyards.
On the passenger side of the engine, toward the front of the side. Near the alternator.
On the 2002 model, it is on the left side (passenger) of the motor. It is the opposite of what we normally expect. The lower radiator hose is what attaches to the thermostat housing, along with the heater hose and overflow tank hose. I ended up buying the thermostat with housing for $27. No one would sell the thermostat by itself.
Yes, it is called the OBD2 code list.
Just remove the console and you can get to it.
On the air intake filter box
Answer confusedhow to change a timing chain in 1999 Oldsmobile intrigue
I found one online for $55 dollars
No car has a "cadillac" converter
on the front of the oil pan the dumbest place i think
To remove the door panel on a 2000 Olds Intrigue, remove the lenses off any lights in the door. Then remove the screws holding in the light assembly. Using a screwdriver, gently pop off the clips in the corners and on the sides.
I'd guess about $350-$400 at a service center for all four wheels. Struts are not a DIY install, unless you have a strut compressor (not likely if you are asking this question).
There is a switch on dashboard next to the fuel door and trunk switch.
attached to the engine near the flywheel You have to go under the car. toward the back of the engine.
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.
Worn tires? Try putting them in different location (front to rear) Bent rim?
Took me about an hour to change mine, but it was the first time.
you might need a thermastat. my 98 was doing the same thing. its easy and cheap to replace.
To remove the shift knob on the 1999 Olds Intrigue look for the pin that is holding the knob in place. Remove the pin and pull up on the knob, replace kob and pin.
Had the same problem after looking all over finly went to the library. It behind the staster.
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.