0
What else can I help you with?
Can the transmission of a 2000 Oldsmobile intrigue be removed from the bottom of car without removing engine?
Yes ... You need to support the engine from above,there is a hanger that attaches to the top of the shock towers that has a hook on it that will support the engine, when you remove the engine cradle (frame) below.
Will an alternator off a 1999 Oldsmobile intrigue fit a 2000 Oldsmobile intrigue?
As long as the 1999 has the 3.5L engine, yes.
What is the engine oil capacity of a 2000 Oldsmobile Intrigue?
6 US Quarts.
How do you check the check engine light on a 2000 Oldsmobile intrigue?
With a scan tool.
How do you change the spark plugs on a 2001 Oldsmobile Intrigue with a 3.5 engine?
how do change the spark plugs and the coil pack on a 2000 Oldsmobile intrigue
Where is the front motor mount on 2000 mercury villager?
At the front of the motor attached to the engine cradle.
Where is the low side service port on the 2000 Intrigue?
Behind the engine on the firewall, about dead center
How many engine mounts in 2000 Mercury villager?
There are 3, or 4 if you count the rear cradle mount.
Is any other year GM engine compatible with 1999 Oldsmobile intrigue's 3.5?
The 2000 and 2001 Intrigue motors are it. The 02s are not completely the same, and the engine is so different from any other V6 GM made..
Where is the fly wheel located on a 2000 olds intrigue?
On a 2000 Oldsmobile Intrigue, the flywheel is located between the engine and the transmission. It is mounted on the rear of the engine's crankshaft and serves as a crucial component in the vehicle's starting and power transmission systems. Accessing the flywheel typically requires removing the transmission.
Where is the starter relay on a 2000 Oldsmobile Intrigue?
attached to the engine near the flywheel You have to go under the car. toward the back of the engine.
On a 2000 Olds Intrigue where is the crankshaft position sensor located?
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
