Eagle Talon
Mitsubishi Eclipse
Mitsubishi Lancer

How do you install a turbo in a 1992 eagle talon?

363738

Top Answer
User Avatar
Wiki User
Answered
2006-04-22 00:16:57
2006-04-22 00:16:57

If it is a non turbo DSM go here, but I recommend just buying a different car unless you have a lot of time and money. http://www.angelfire.com/il2/freestyle/turboconversion.html or http://www.dsmtuners.com/forums/showthread.php?t=48231

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Yes, but the flywheel and pressure plate is diferent between turbo and non turbo.

Notice where the exhaust manifold is. Now look down and you can see your turbo. If it's not there then you don't have one.

v-tec b18 b16 is it AWD? no it is not awd its fwd and its non turbo

Yes much trouble. The motor mounts are not the same as well as the axels. It would be easier for you to convert the 420a engine to a turbo modified. They make turbos kits for the 420a

yes it will, but the manifold your gonna put the tsi throttle body on must be a turbo manifold as well, well actually not really, it will fit no matter what, its just the non turbo manifold has more vacuum lines runnin to the throttle body, but it should work, never had a non turbo talon but i am very familiar with them, i have a 92 tsi awd talon and a 98 tsi.

If they both have the 4g63 2.0l motor then yes

Chrysler recommends using Champion spark plugs and gapping at 0.35 (in thousandths of an inch).

uh there's a manifold on the front of the motor that's your turbo manifold and the turbo's connected to that it's the easiest part to spot other than the motor and intake your intake goes into it

any battery with at least 550cca (cold cranking amps) and at least 685ca (cranking amps.

Remove the tire and wheel from your 1992 Eagle. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.

just get a 6bolt 4g63t have to get the wiring harness transmission ecu it's just best to buy a tsi/gsx/gst you'll spend to much money on it

Mitsubishi 14b turbos were put into these cars until 1995 when the Garrett t-25 (smaller spooled faster but less HP) was installed.

yes you can, i have a 1992 eagle talon tsi awd turbo, and i also have a 98 talon tsi and since the 95-98 mmodels have a 7 bolt pattern, im sure you know, crank walk etc, i threw in a 2.0 engine into my 98 modded the hell out of it to, super easy, great fit, go for it

Look at the lower section of engine - follow + battery cable

Chrysler products do not use inertia/reset switches.

"it most certainly will"Let's eleborate on that. Yes it CAN, but you still have to make some modifications to make it work. If you are buying a junkyard engine to install then you need to do your homework, because it will NOT simply plug and play. The motor may fit, but the engine management is different between the two cars, and that will cause you problems.

take the negative termainal on the battery off for 30 seconds then reconect

check the dsm tuners web site or buy a manual the talons are interferance engines if you do it wrong the valves will contact the pistons this is abig job that should be done by somebody with experience

Yes you Can... it is extremely easy! You would do it like you were putting the 92 engine back in it!!


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.