Most 2.5 inch lift kits are pretty simple. These trucks have leaf springs in the front and back. Blocks should be put between the leaf springs and the axel in the back (longer u-bolts may be required). In the front people usually put an additional leaf spring and brackets need to be installed to lower the inner hinges of the twin i-beam suspinsion. That's about it. If you go much higher than 3 inches you will need to lower the differential so that the drive shafts are not at so much of an angle
f250 superduty is a 3/4 ton pickup
half inch..
2143
I have a 1979 ford ex cab half ton 4x4 with front leaf springs not coil springs is it a high boy?
It is in the right half of the engine air cleaner.
It appears that there were 337,068 Ford F150's were manufactured in 1977. In comparison, there were almost half as many F250's produced that same year. The number is decreased significantly for the F350 at 52,493 trucks.
the filter is sitting on the top of the engine under a black cap.... the drain is yellow and behind the black cap about half inch down.
get a expert to do it, and youll save half the time. dont do it yourself espicially with glue? Answer You do not need glue to install a windshield
I know of no 1997 Ford Escort equipped with a 1.4 L engine sold in the U.S. The 1997 Ford Escort with a timing chain is the 2.0 L engine. All 1997 Ford Escorts 2.0 L sold in the U.S. are non-interferance engines. No engine damage occurs when the belt breaks. If you have a 1.4 L Ford Escort, I suggest you cantact your local Ford dealer.
1 - 3 - 7 - 2 - 6 - 5 - 4 - 8
He is half German and half English. End of story.
how do you replace half shaft on 2992 ford escape