The trailer wiring kit is available from Jeep at about $125 and plugs into a wiring connector accessible through a panel in the left rear (inside) fender panel (behind the spare tire, near the left rear turn signal) with the trailer wiring harness routed through a grommet in the bottom of the compartment
If it is like a 99, just remove the plastic panel behind the spare tire on the drivers side in the back. In one of the cut-outs you will see connector plugs that connect the harness to the tail lights. Good luck. go behind the spare tire, there is a panel that has to be removed. You will see some black connectors in there. You can by a wiring harrness that will plug into there without any cutting of the factory wiring harness. These work fantasic, as I have one in my 2001 Cherokee. this is very easy to do has the new harness plugs right into the vehicles. You can find this wiring harness at Walmart or any parts store it is made by Hoppe. Good luck and I hope I helped you. Semper Fi
Jeep Cherokee's are unibody. You cannot install a body lift.
you have to remove the back driver trim in the back of the jeep..........you will find a green plug, the aftermarket wiring will plug into that.......................good luck
how to install a fuel pump on a 2000 jeep Cherokee 6 cylc
I took mine in to Uhaul to have them install a tow bar and light harness. Mine didn't come with a light harness, they had to install one.
Cherokee is a hard top only vehicle.
How do you install passenger tail light kit for a 2004 grand cherokee?
You dont.
You can buy a speaker harness. An adapter that connect the positive and negative from the speaker into the stock harness.
Yes depending on if you have on star or not requires different harness
To install an aftermarket CD player in a Toyota Corolla a new wire harness is needed that corresponds with the replacement player. The old radio needs to be removed and the harness will need to connect to the cabin harness. Then the new CD player can be installed.
the radio owners manual that came with it, a install harness with instructions 2 hours,twist connectors, and understanding.