Chevy Malibu

How do you install an amplifier to a stock stereo in a 1999 Chevy Malibu ls?

303132

Top Answer
User Avatar
Wiki User
2011-09-13 04:47:46
2011-09-13 04:47:46

you need to buy a FM modulater and splice that into your rear speaker wires i would also recommend a noise reduction block to kill all the extra roadnoise

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the stereo in my 2000 Chevy Malibu is in lock mode and i don't know the codes, how do i unlock it?

User Avatar

The amplifier is mounted under the dashboard on the driver's side. It is to the left of the steering column

User Avatar

the thermostat is in the coolant cap

User Avatar

If you do not have the code then you will have to go to the dealership and give them the VIN in order to get it.

User Avatar

u have to go to the shop and buy it and pay the shop to install it

User Avatar

Have you had the stereo replaced or upgraded? If so, they probly didnt install the proper install kit for the door chimes to work. The chimes are intergrated into the stereo system.

User Avatar

Remove the belt from your 1999 Chevy Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.

User Avatar

You can tell if the transmission, in your 1998 Chevy Malibu, is going bad. If there is a whining or clunking noise. The transmission might cause your engine to install when you are stopped with your foot on the brake.

User Avatar

Chevy did not build Malibu in '94

User Avatar

I have a 2002 demo model, and its 60 watts per channel. peak power not rms.

User Avatar

It is the silver box located under the drivers seat underneath the carpeting It powers the rear door speakers and such.

User Avatar

A 2007 Chevy Avalanche will only have an external factory amplifier if it is equipped with a Bose stereo system. If there is a factory amp included, it will be underneath the center console.

User Avatar

Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

Pull out the ashtray and pop out the panel covering your stock radio, a/c, & tape player. It just snaps out. Unscrew the 2 screws holding the factory radio in. Install your after-market radio and pop the cover panel back on. Seems almost to easy right?

User Avatar

where do you find the replacement bulb for a 2001 Chevy Malibu ls for fog light replace ment on the car

User Avatar

No. If you are looking to install a amplifier, either install an aftermarket head unit or buy an amp that has speaker level inputs.

User Avatar

fuel systemfor 1998 chevy malibu

User Avatar

How mcuch does a 2003 Chevy Malibu weigh?

User Avatar

Where is the oil filter in a 2004 Chevy Malibu

User Avatar

HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU

User Avatar

the stereo is probably done. it would probably cost more money to have the stereo looked at than to buy a new radio.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.