Want this question answered?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
The electronic ignition control module on an automobile is installed by first locating the unit at the top of the engine. The wiring harness is then disconnected from the original unit an a new module put in its place.
no it has a distributorless ignition system. it cosists off two coil packs and the ignition control module that sits under them
At the deal it'll cost about $650 for new module and labor to install and program it.
In the front of the motor by the transmission dipstick. This is where your spark plugs from the engine go.
Under ignition coils
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
The ignition module is under the ignition coils The coils are bolted to the frt of the transmission housing. Follow the ignition wires to the coils The coils are bolted to the module underneath The module control spark to the spark plugs. It sends the required signal to the coil as to when to fire t then fires and "sends" the spark through the ignition wire to the spark plug
Where is the ignition control module located in my 1992 Crown Victoria
The ignition control module sit directly below the distributor.
ignition control module is under the distributor cap
Where is ignition control module on a 2001 mercury sable