answersLogoWhite
Ask
Chevy Astro

How do you install an ignition switch on a 1994 Chevy Astro Van?

646566
Answer

Top Answer
User Avatar
Wiki User
2012-01-24 20:27:14
2012-01-24 20:27:14

You will need to remove the steering wheel to gain access to a screw which holds the cylinder in the steering colum. But if there is an air bag you will need to disconnect the battery then remove the air bag then you'll need to remove the pressure plate then the signal harness. After doing all that you'll see a screww at 3 o'clock which is either a torx screw or a hex head screw. aftyer removing the screw then pull on the cylinder and it'll come out in your hand then insert new one. I hope this helped

need to know how to remove the steering colum?

1
0

Related Questions

User Avatar

You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.

User Avatar

To bypass the ignition switch on a 1994 Chevy Astro, simply attach a wire to the ignition switch where it makes contact after the key is turned on. Run the wire to the push button and install at the lower part of the ignition switch to send power to the starter. Ê

User Avatar

how do you install new ignition switch on 1989 chevy G10 van?

User Avatar

how do install key ignition switch 1988 Chevy s10

User Avatar

Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.