First, ensure that the child seat is not in front of a working air bag. If installing in the passenger seat, disable the airbag. Otherwise, install as normal using either the LATCH system or the seatbelt.
are you serious?? im sure there are directions in a packet that comes with a child seat when you buy it.
Put a paperclip into the small holes on the side of the plastic at the seat.
Infant snugride car seat http://www.youtube.com/watch?v=ROpOJBsS1og BEST ONE!! Check it out http://blog.gracobaby.com/2009/07/10/graco-car-seat-installation-videos/
AT FIRST REMOVE BENCH SEAT THEN INSTALL ROLL CAGE WITH ATLEAST THREE SEAT POSITIONS. THEN INSTALL THE CORRECT 2 POINT HARNESS AND YOU ARE GOOD TO GO. OH BUY THE WAY THE BENCH SEAT IS A BENCH SEAT FOR A REASON YOU DONT NEED SHOULDER BELTS ON A BENCH SEAT.
Under the drivers seat.
My child seat car bolt, is in a 1988 Sundance, passenger side about 1 ft from behind back seat, on trunk floor.
You should not try to install seat belts yourself, it says so in your owners manual. Plus it is dangerous, because if you don't do it properly, you can kill anyone sitting in that seat. Take it a professional, A seat belt equals life!
Look behind the seat where you will find complete instructions on how to remove the tire. Also listed in your owner's manual.
As far as I know, any child under the age of 12 should not ride in the front seat. Especially if you have a passenger air bag.
We would need to know the state. You may want to call your police department and ask them about it, they can also help you put it in right. I know where I am, you can't put a child in the front seat of any truck or car.
I have a 03 silverado and the jack is under the back seat on the passenger side
Should be a bolt in each corner of the seat