The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
ignition what? coil, swicth,module, lock cylinder? gm Jim
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
how much to insall a ignition to a pontiac grand am se 1999?
Install what?
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.
How_do_you_install_a_pontiac_grand_am_grill
Where is the starter on a 1998 Pontiac Grand Am, 6 cylinder
The firing order on a 1987 Pontiac Grand Am 3.0 V-6 is 1, 6, 5, 4, 3, 2. The number one cylinder is on the front left as you face it.
the steering wheel..
it is located on the steering column