I don't have the manual, but this worked for me. 1. You need .065 trimmer replacement line. Any hardware store will have it. 2. Unplug the trimmer. 3. To remove the spool, turn the trimmer over and look at the bottom of the cutter head. On the sides are two small panels with 3 chevrons on them. Push in on these and pull the cover off. The spool should come out easily. 4. The spool has arrows showing the direction of rewinding the string (clockwise). 5. This is a two-string trimmer so you have to wind two pieces of string. Looking down on the spool (with lettering on top) start with the upper slot. Inside the slot are two holes, each on opposite sides. Push a small amount of string into this hole in the direction of the arrow. Then begin winding string on, also in the direction of the arrow (clockwise). The first bit of string you put in the hole should act as a "hook" so the string doesn't come out. 6. Don't fill the slot too full. Leave about 1/4 or 1/8 inch of free space. When you are done, cut the line and use the notches on top to hold the line while you do the lower slot. 7. Repeat steps 5 and 6 for the lower slot. 8. Drop the spool back into the trimmer. Thread the string through the holes in the head one at a time. One string for each hole. You'll need at least 2 inches of line sticking through the hole. Don't worry about too much line, the trimmer will cut it too the right length. 9. Snap the cover back on. 10. Plug in trimmer and go.
If the bump knob is turned it will come off. Once the knob is off there will be two holes to feed the string in to , there will also be arrows showing the direction in which to roll the string on.
pray
40:1 owner's manual for a homelite st 185 trimmer says 32:1
50:1
50:1
40 to 1
50:1 gas to 2 cycle oil.
weed-ate, or cut with the string trimmer
A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.
0.080" per 1993 manual
50:1 1 //1 usgal with 2.6 oz 2cycle oil
ya mums uncles greatgrandfathers dogs brother in law
Installing new string on a Homelite 26ss weed eater is very easy. You will need to take off the empty spool and put the new one on. Take two pieces of the strings and put each in one of the empty slots opposite each other. The put the spool and grasp the strings pulling them into place.