It isn't hard to do. After buying the plug wires, remove one by unplugging it from the distritutor and plug. There may be some clips holding it on the engine as well. Take the wire and find the new wire that is the same length. Install the new wire the same as the old one was. Do that seven more times and that's it. good luck.
when you pick up the fuse cover under the motor there should be a diagram on the inside of the cover. # when you pick up the fuse cover under the motor there should be a diagram on the inside of the cover.
You can find the diagram in a 1976 Motor Guide. You should be able to pick one up on eBay for about 15 bucks.
pick up a Chilton's manual it has that and alot more and for about 30 bucks its a must have
It depends on the make and model of the vehicle. Look on AllTrade. 1990 Dodge Dakota pick up
Possible blown fuse from crossed wires.
You left out which engine the 3.1 or 3.4. See link below and pick the correct engine.
The easiest way is to buy and install a plug in wiring harness available at most parts store.
Well, if you had listed the year, and engine size, I could help. I will just post you a link. Go there and pick the proper year and engine size.
autozone.com has some free ones. Otherwise buy a subscription to alldatadiy
You can pick up a tear down and rebuild manual from your local auto parts store. I have a Haynes manual and it does fairly well.. Not real detail on the wiring and I have found there are a few things that it doesn't list. Your local Dodge dealer may be able to get a diagram for the particular project that you are working on.
Need to know a diagram of what.
These diagrams can be easy to find. It is best to look through the users manual or to find an image online.