Do not install the shims. Your starter should work fine.
Pull your starter down, the cylinder on top of the starter that the main 12v cable is bolted to is what you are looking for. jr
you shouldn't need a diagram...the starter is a cylinder shaped object that is bolted to the motor...it has 3 bolts holding it to the motor...one plug that runs from the starter(very small plug)...you are looking for a small electric motor that mounts to the engine...you can't miss it with all that space you have in that old chevy...small electric motor with one wire and three bolts the bolt pattern is usually triangular
How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?
Begin by removing the positive cable from your 1991 Pontiac Grand Am battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
16.5 to 17.1 gal
Push it back as far as you can then push it up or pull it down until the "nose" of the starter clears and remove the starter, you will have to reverse the way you removed it to re-install it.
yes you can
follow the red wire from the battery
Four cylinder it is on the back, under the manifolds. Six cylinder, it is on the front under the exhaust manifold.
Maybe not aligned properly may have to install shims
Remove the - battey cable Raise and support vehicle Disconnect wires at the top of starter Remove starter mounting bolts Remove starter
165432 #1 cylinder is left front
Remove the battery cable from the positive post of the battery. Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.
the starter is located on the passenger side of the engine beneath the exhaust manifold.
160 foot lbs
It is screewed into the passenger side of the engine, just in front of the starter.
Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring harness at the top of starter Remove starter mounting bolts Remove starter
The fusible links are all on the large terminal on the starter - The one the battery cable hooks to.
Four cylinder, it is on the back of the engine under the exhaust manifold. Six cylinder it is on the front of the engine, below the exhaust manifold.
yes but it will so mess up the mileage.
You didn't mention what engine it has but, if you follow the positive battery cable from the battery, it will lead right to the starter.