Chevy Trucks and SUVs

How do you install the fuel pump on a 1984 Chevy truck when the push rod falls out of the block?

345

Top Answer
User Avatar
Wiki User
Answered
2008-10-05 20:25:27
2008-10-05 20:25:27

Put a gob of wheel bearing grease on the push rod before you install it. It will stay up by itself long enough to get the new pump in.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Yeah, but, I would use the Chevy trans, as well. You will have to fabricate everything.


yes you can but you need to cut some of the sides to make it fit


1952 chevy truck does not have a steering damper, where and how to mount steering damper on my 1952 chevy truck .thanks jim


where can i find a vaccum diagram for a 1985 Chevy truck with a 350 small block



is there a diagram of a fuse block for a chevy one ton utility truck available over the internet?


can a tow bed be wielded to frame of a truck or does it have to be boilted down


1983-1987 454 out of a light duty truck


These are simple bolt-on parts, there is no special procedure to install them.


u have to go to the shop and buy it and pay the shop to install it


the big Chevy truck rod is bigger than a passenger car rod.


The 1995 Chevy truck did not come equipped with an ashtray light. It may; however, be possible to purchase an after market light to install.


Best bet would be to pick up a factory service manual or one of the aftermarket manuals such as Chilton's, Motor's, or Haynes.


How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?



There is not a 350 engine known as a "big block". If the caprice and the truck are the same year it should fit perfectly.


From the inside. you have to unbolt heater box




No it will not even BOLT UP to the 20OO year engine block. Chevy redesigned the transmissions and engine blocks in late 1999. Will not interchange.


There is such a thing as a 454 truck engine, also 454 passenger car engine.


It's the part of the transmission that bolts to the engine block.


Will a 95 cheve 1500 back windo fit a 97 cheve 1500 truck


Bearings are dirt cheap-never install a used one.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.