Want this question answered?
Jack up the license plate and put a Mustang under it.
Check your fuses.
park light circuit.
Remove 1. Bolts retaining license plate lamp to bumper. 2. Socket from license plate lamp. 3. License plate lamp. 4. Bulb from socket. Install or Connect 1. New bulb to socket. 2. Socket to license plate lamp. 3. License plate lamp. 4. Bolts to retain license plate lamp to bumper.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
Go to the dealership and purchase a license plate holder. There should be instructions as to the installation. You will need to drill 3 holes,denoted by dimples, in the bumper. Install the holder and then your tag.
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
if it has a connector it will be behind the license plate or you have to install one
The following Instructions are for all 1991, 92, 93 DeVille Sedans and Coupes.Remove rear license plate.Remove 4 nuts underneath license plate.Separate license pocket (with reverse lights) from body.Remove license plate lamp socket from license plate pocket (1/4 turn counter clockwise)Pull bulb (straight out) from socket.Push new bulb into socket (line up blade to slot in socket).Install license plate lamp socket to license plate pocket (1/4 turn clockwise)Install license pocket (with reverse lights) on to body.Install 4 nuts underneath license plate.Install rear license plate.
Throttle plate may be stuck With engine off try sticking a screwdriver into throttle body and freeing up plate
The license plate lights are located just above the license plate. Open the tail gate part way to make removal easier (unless you enjoy squatting). Remove the Phillips screws and replace the affected bulb.
There is a plate mounting bracket available from the Range Rover dealer. You can also have the dealer install it if you don't want to drill holes through your bumper.