Lightly losen the lug nuts with the tires on the the ground. Jack up the car and remove the tire according to the owner's manual. Make sure to block the wheels. After the tire is removed, release the park brake. Support the car on jack stands. Remove four bolts from the rear of hub. The hub nut will be 29 mm - it is important that you have a tight fit if you attempt to remove the nut.
At this point you MAY have to loosen or remove the remove the emergency brake cable. Either way the hub is ready to be removed. The front of the hub (with the lugs) and the bearing will come out and the back plate and brake shoes will remain in place.
Once you get it off, you may either purchase a hub assembly (which includes the hub with a new bearing in place ready-to-go) or take the existing hub and a replacement bearing to an auto machine shop which can easily remove the old bearing and install the new bearing. Using extreme care you can remove the old one using bearing pullers and prybars and replace the bearing using large deep sockets or a properly sized piece of steel pipe.
Since you have the hub apart, you should inspect the brake shoes and (brake) wheel cylinders and replace them as needed. Replace brake parts on both sides if you replace them on either.
Put the hub back into the brake shoes. It may only line up one way. Finger tighten ALL FOUR of the bolts and then tighten. Replace the tire and remove the lifting equipment. Start slowly so the brakes can readjust!
You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Changing wheel bearing from a 2002 Hyundai Elantra requires removing the hub assembly. The bearing will need to be pressed out and in to confirm and safe install.
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
If it is the front bearing: Take it to a mechanic. The bearing in pressed into the spindle. A press is required to remove the old bearing and install the new one.
A wheel bearing could be going bad in a 2002 Ford Focus if a grinding or rubbing sound is heard. A trip to a mechanic is advised as a bad wheel bearing that's not fixed can lead to damaged brakes.
You can't, it is a sealed wheel bearing.
Yes , a 2002 Ford Focus is front wheel drive
The 2002 Ford Focus has front wheel drive.
The 2002 Ford Focus has a 8 ft. 7 in. (103 in.) wheel base.
Remove the dust cap on the brake drum. There is a 30MM laminate nut under it. This is torqued to 192 Ft lbs remove it and the brake drum will come off leaving the wheel spindle and brakes in place. The drum actually hold the bearing a new seal should be added as well since you have the drum off
Yes.