Take it to a Chevy dealership.
how do you install trunk light on 2001 impala
weher thermostat locaked for impala 2001
You can replace the thermostat on your 2010 Chevy Impala 3.5 by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will come right out. Reverse the process to install the new thermostat.
AnswerYou_want_to_put_a_sony_CD_player_in_your_2000_chevy_impala_and_take_out_the_stock_AM_FM_radio_can_you_do_that
Where is the mounting bolt on a 2001 Chevy impala so I can replace the bletAnswerWhere is the mounting bolt on a 2001 Chevy impala so I can replace the blet AnswerWhere is the mounting bolt on a 2001 Chevy impala so I can replace the blet
If a 2001 Chevy Impala will not start after replacing a thermostat, perhaps it is possible that a sensor was bumped unknowingly. Check all of the sensors that might have been touched during the changing of the thermostat to see that they are all still plugged in.
Motor
Drain the radiator into a container. Remove the upper hose at the engine end. Remove the 2 bolts in the thermostat housing and remove the thermostat. Clean both surfaces and install the thermostat "O" ring. Install the thermostat ,housing and 2 retaining bolts. Install the upper hose and fill the coolant recovery tank.jd
Drain the radiator into a container. Remove the upper radiator hose at the engine. Remove the2 bolts on the thermostat housing and lift it up. Remove the thermostat and clean the surfaces. Install the thermostat and the bolts. install the top radiator hoes and fill the radiator.jd
If you do it yourself, it's a 15 minute job and a thermostat and gasket won't run more than $10.
Drain the radiator down 1/2 way. At the engine end of the top radiator hose is the thermostat housing. Remove the housing and install a new thermostat.
Partially drain the radiator into a container. Remove the upper hose at the engine end. Remove the 2 bolts that hold the thermostat housing and remove the thermostat. Clean both surfaces and install the thermostat, install the housing and the 2 retaining bolts. install the upper radiator hose and top off the coolant. It is located at the engine end of the top radiator hose in the thermostat housing.