0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you install a signal turn knob on a 1977 Corvette?
www.automotiveforums.com should be able to help you out If you're talking about the lever it should unscrew from it's mount in the column. It just threads right in. Lefty/loosey, righty/tighty....
How do you install seat covers on a 1977 Corvette?
what is the process for installing new seat covers in a 1977 chevrolet corvette
How do you install power window switches for a 1977 Corvette?
How do I replace the power window switch on 1977 Corvette coupe
Where is the turn signal flasher located on 1977 corvette?
Under the dash near the fuse block.
What is a 1977 Corvette?
A Corvette that was built in late 1976 up to late 1977.
What does the label for the turn signal fuse in a 1977 Corvette say?
It should say either..."DIR SIG-BACKUP" OR "TURN/BU"
Where can you find a diagram for the parking brake on a 1977 Chevy Corvette?
Which diagram do you need, the one for the lever assembly or one for the rear brake assembly? Let me know and I can send them to you.
What is the spark plug gap for a 1977 Corvette?
Spark plug gap for a 1977 Corvette using ACDelco R45TS is .035
Where is the dimmer switch on 1977 Corvette?
The dimmer switch is located on the turn signal switch. Pull it toward you to switch from low to high or high to low beam lights.
Where is high beam switch location on 1977 corvette?
It is on the signal light switch. Pulling it toward you will change from High to Low beam lights and vice-versa 7T77T7
Do you have a diagram of a 1977 corvette horn assembly?
You can find a diagram of a 1977 Corvette horn assembly at your local library. Look in the car repair section for a Corvette repair book.
How do you remove turn signal lever from switch 1977 corvette?
All you need to do is pull it out. If it broke off like mine did then you take a drill and small drill bit and drill a small pilot hole and use a drywall screw. Run it in and pull it out with that. Be careful not to strip the drywall screw in or you"ll have to drill deeper and do it again.
