seeing you have the old one off, just place new wheel cylinder on backing plate and put the 2 bolts in the new cylinder and tighten then down and then reinstall the brake line into the new cylinder and it's on, just don't forget to bleed your rear brakes when you have it all back together.
On the steering wheel. What exactly are you looking for?
Remove wheel Remove brake drum Loosen and remove brake line Remove mounting bolts Pry wheel cylinder off brake shoes Install new cylinder Replace brake lines Replace brake drum Bleed affected brake line
do a 1997 cutlass olds. have fusible link
Remove wheel and brake drum, disassemble brake parts, disconnect brake line from back side, remove 2 bolts holding cylinder on from backside of brake plate, install new one, tighten bolts, attach brake line, reassemble brake, reattach wheel, and bleed brakes.
the front wheels have no bearings
Under the hood. Drivers side. In a box above the wheel opening, under a support strut.
You will need to remove the tire and wheel from your 1997 Suzuki. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.
Yes, you will need to install the 1997 oil pan and intake manifold.
Remove the tire and wheel from your 1997 Chevy Lumina. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new wheel bearing.
You need gauges and a refrigerant recovery system.
remove the right front wheel, then you can see it, tough to get at.
There