With something conductive - like wires or a circuit board.
a latch
You should use a mechanism called persistance of vision for interfacing multiple seven segment displays. here is tutorial for mulplexing displays using 8051 microcontroller. http://www.shree-electronics.com/interfacing_multiple_7_segment_displays.htm
A seven segment display is a device used to display numbers and letters on things such as alarm clocks. A 7 segment display is simply seven LED's packaged in a pattern that allows numbers and letters to be displayed by illuminating different sets of LED's.
We cannot connect the 74ls138 straight with a seven segment display; for that we need a 7447(7 segment driver).
A: NO it is a display of seven segment to display a decimal of '0' to '9' it may have 8 LED for the point
A 7 segment display is an I/O device, and it is not necessarily used in microprocessors. The choice of I/O devices is a function of system design, not microprocessor design.
To connect a common anode 7-segment display, you would typically connect the common anode pin to a positive voltage source and the individual segment pins to current-limiting resistors connected to the microcontroller output pins. When you provide a LOW signal to a segment pin, it will turn on that segment.
recheck ur que first................ 2 or 7
10
common pin connected to supply
A Loss of power or the blanking signal is on to begin with.
it works on the principle of seven segment display. according to the number the respective lines ,among 7 ,are displayed.