Want this question answered?
An O-ring is a seal. The O-ring goes between two separate parts to either keep fluids in order to keep fluids from getting in.
There is an O-ring on the petcock. You will need to replace the O-ring/petcock.
Pretty vague question but most o-rings provide a seal to keep fluids in and contaminants out.
O-rings are usually found in water proof flashlights. The ring is used to keep the water from the electrical components in case the flashlight gets submerged in water.
Ring a Ring o' Roses was created in 1881.
'O' refers not to the shape of the ring but to the ring's cross-section.
Depends on what type of o-ring it is.
An o-ring goes around a bracket to keep the wire in place.
Ring o' ring o' roses
O Ring for what component.
What are symptoms of a bad o-ring in a pipette
1) The injector is pulled from the insert, with main O-ring and end cap/small O-ring together 2) The end cap is removed from the injector with plyers. Replace the O-ring now, or before installing the injector) 3) Remove the "C" clip (the old, large O-ring can just be cut or pried off - mine were dried and brittle) 4) Take the new O-ring (after soaking in a little gas) and slide it over the injector until it seats in it's groove 5) Reinstall the "C" clip 6) Reinstall the end cap 7) Remove/install inserts if you want to clean them 8) Smear a little oil on the O-rings and insert the injectors