0
How do you know how to place wires from sparkplug to the correct place on distributor on a 1986 s10 2.5?
Wiki User
∙ 9y ago
Replace one at a time.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where can you find a diagram to correct the wires from the distributor to the plugs in 95 ford e250?
where can you find a diagram to correct the wires from the distributor to the spark plugs on 95 ford e250?
What is the ignition timing on a 1990 Ford Probe v6?
look up the engine cylinder numbers, then look at the front of your engine, or on the intake manifold. There will be a series of raised numbers, (you may have to clean off some grease), this is your timing order. Make sure you have the correct sparkplug wires going to the correct plug from your distributor.(make sure your distributor is mounted correctly) Jody
What is the correct placement of distributor wires from the spark plug to the distributor cap on a 1992 Acura Vigor?
123c54
Where is cylinder three?
Find where all your sparkplug wires lead to, one side of the wire will end up connecting to the sparkplug in the engine block, the other side will lead to a distributor or ignition coil pack, eather will indicate the cylinder the wire is hooked up to.
What is the correct placement of distributor wires from the spark plug to the distributor cap on a 1985 Ford Mustang 5.0 liter?
15426378
I cannot remove wires from distributor cap on 454 engine C60 1969 chevy.?
on this old distributor there is a cap that holds the wires in place on the distributor. Is there a trick to remove top cap?
How do you replace the ignition coil on a 86 Chevy Cavalier?
Aren't they inside the distributor cap on that model? It's probably just two screws and it comes right out, then unplug the wires. BTW, make sure you mark the sparkplug wires with a piece of tape or some other way to show which wires go to which position on the distributor. You don't want to get them crossed.
What happens if the wires on a distributor cap is wrong?
Engine will misfire, or may not start if enough wires are in the wrong place.
What is the correct configuration of distributor wires from the spark plug to the distributor cap on a 1987 ford 460 engine?
that is stamp on the intake right rear. 65;
Why doesn't 1985 blazer start after replacing coil rotor and distributor cap?
are the plug wires in the correct sequence for firing order? Are the coil wires all connected? Did you remove the distributor and possibly put it out of time?
Does 1998 Town Car has Distributor Where is it?
If it has a distributor, then all the plug wires will merge at the distributor. Follow the wires.
How hard is it to change a distributor panel on a 1996 Chevy silverado 350 Vortec Z71?
Distributor panel?? If you mean distributor cap, you first move the air intake going to the throttle body. Mark all spark plugs wires with the correct plug and unplug each one at the spark plug. Next you will find 2 screws holding the distributor cap. Remove both screws and and lift off the cap and wires while the wires are still connected to the cap. Take the spark plug wires off and place them onto the new cap in the same position you removed them. Put new cap on and tighten the screws and replace the wires to the correct spark plug. You should replace the wires and rotor button when you do this also.
