0
How do you know if a drive shaft is going bad on a 1993 Chrysler Lebaron Convertable?
Wiki User
∙ 15y ago
It will make noise underneath the car especially when you turn the wheel
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
You have a 1993 Chrysler LeBaron and it stalls out and has bump vibration to it when you stopCan you help?
i had the same prob. with mine i have a 92 lebaron 3.0 and it was the fuel pump going bad...
Why on a 1995 Chrysler Lebaron the radio's on but no sound?
check 9 pin plug in the back of radio also check wires going to speakers
How do you change the rear speakers on a 1985 Chrysler Lebaron coupe?
If its anything like my 88 lebaron convertible on the inside your going to have to take out the trim on the floor by the door and then take off the whole side panel in the back seat...a pain!
What size wipers do you need for a 2002 Chrysler Sebring?
Going under the assumption that you meant 2002 Chrysler Sebring, it depends on if you have sedan, coupe or convertable. See sources and related links below for all wiper blade size information.
Where is the motor for the top on a 1994 Chrysler Lebaron located?
The motors for the convertable top are in the trunk in the very back behind spare tire there is a up motor and a down motor.I believe the driver side motor is the up motor. There is one motor/pump assembly and it is located directly behind the rear passenger seat. It can be accessed by removing the rear seat or by going through the trunk.
Will your 1992 Chrysler lebaron make noise if the front left differetial is going out its making a grinding sound changed axle and wheel bearing?
Yes, the differential can make a grinding sound.
Why is your Chrysler van going in reverse when you put it in drive?
Is every gear essentially reverse now?
Who sings the song off the Chrysler drive love commercial that goes I'm going to get where i am going I'm going to get there when i do maybe I'll see you?
This is by Chris Hero, and it is on the saves the Dave album.
Why would a 90 Chrysler Lebaron not go into 3rd gear and the RPM's go up and stay up and the car just shuts off while driving?
your trans is going into "limp" mode, stays in second gear to allow you to drive to a shop. usually caused by a faulty input or output speed sensor or the solonoid pack. needs diagnostic reader to determine which.
Chrysler going out of business list?
Due to the recession Chrysler car company is going out of business.
What is the alternator belt routing diagram for a 93 Chrysler lebaron?
You dont need a diagram.. just trace the route with the eye.. Besides.. if your going to change the alternator belt.. you might as well change all 3 if its on the V6.. Oh.. and is a PIA job..
Is the new Camero going to come out as a convertable?
Presently there is one slated for production for the 2011 model year
