Crawl under the vehicle and look. If it is broke this will be easy to spot.
Outside Rear View Mirror..Manually operated r conventional..Modern cars has electrically adjustable ORVM's....
To replace a rear wheel bearing of a VT Commodore, remove the hub from the car and press it in and out. The bearing has an inner and outer seal. The inner seal has a magnet for the abs sensor. Make sure to install the new bearing before the abs will pick up a speed fault.
Replace the rear glass if you have determined all else in the system is working. The element wires are sandwiched between the inner and outer glass and are not serviceable of anything but the 240 series.
In order to dissemble the rear axle on a 2000 Honda TRX 300 first determine if it is inner or outer joint. You then remove the retaining ring behind the boot to access the axle.
Depends on the vehicle. Each wheel has an inner and outer pad. So if it has front disk brakes, 4 in total. If the vehicle has rear disk brakes also, another 4 pads for the rear wheels
In the rear differential assembly of some cars, which allows the inner and outer wheels to turn at different speeds while cornering
This is normally a resistive heating fixed to the inner surface of the glass of the rear screen.
Yes, that is possible.
It could be that the connector wire broke in the rear. It happened to me.
usually at the outer ends of the rear axle behind the backing plate
Could be either. You need to have someone who knows about rear axles look at it.
In many cases they are lubricated from the gear oil in the differential.