0
How do you know if the bulb is bad or the igniter on a 2002 acura 3.2?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the fuse number for a cigarette lighter on a 2002 Acura MDX?
I need to know what number fuse is for a cigarette lighter in an acura mdx
How do you test 1994 Toyota Camry igniter?
Replace it with a know good one, if that fixes your problem then its the igniter.
Do 2005 acura rl's let you know when you have a light out ex headlight brake light etc?
yes itll say bulb failure on the dash by the speedometer
Does anyone know where I can get a turn signal bulb socket for a 2002 Durango?
salvage yard would be the cheapest
How do you know how to change the front light bulb on a 2002 Malibu car?
Remove the light bulb connector from the light. Take hold of the light bulb, push in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
How do i know if igniter or coil is bad on 91 accord?
if fails to start or it dies randomly.
What is 2002 Oldsmobile intrigue bulb size?
You should specify which bulb. As is, we don't know if you're talking about headlights, tail lights, or any other number of bulbs that vehicle requires.
How do you replace the hid bulbs on a 2001 Acura CL?
I had to pull off the front bumper to replace the ballast and high and low beam bulbs. that's the only way that I know. I had to do this 2 times when the other bulb went out.If the bulb you replace does not work then it might be the ballast.
What can you do if the radio is locked on Acura TL?
If your radio is locked and you DONT know the passcode then you need to call Acura....but if you do know the password...then you should enter it
What is wrong with a 1989 Cressida if you can't get a spark from the coil?
If you know the coil is good then the Igniter is bad. It is right below the coil.
How do you replace a Cadillac bulb?
need to know what bulb. The check engine bulb
Pilot light is on but flames wont light when you turn up the thermostat?
This question is not specific enough for a good answer. What is the appliance? A furnace? A cooktop burner? An oven? The first thing to check would be the igniter, which is what typically "lights" the gas coming from the valve. You can check an igniter with a simple continuity test using a test meter. If the pilot is lit, then there is no igniter, or the igniter lites the pilot, so if the pilot is lit how could it be the igniter. Bad thermocouple, this tells the gas valve that the pilot light is lit, if the gas valve does not know the pilot is lit it will not allow gas to come out of the valve, this is a safety feature so your unit does not blow up.
